CLI Ping getting failed results
CLI Command on Zyxel USG Flex 200 not getting results I should
The LAN IP is 172.16.24.1
I can ping 8.8.8.8 from the Gui Diags, but when I go to the CLI and use this command it does not work
ping 8.8.8.8 source 192.16.24.1 (It fails all 3 packets)
OR
ping 8.8.8.8 source 192.16.24.1 interface wan1 (It fails all 3 packets)
OR
ping 8.8.8.8 source 192.16.24.1 interface eth2 (It fails all 3 packets) )eth2 is wan1 Interface)
The LAN IP is 172.16.24.1
I can ping 8.8.8.8 from the Gui Diags, but when I go to the CLI and use this command it does not work
ping 8.8.8.8 source 192.16.24.1 (It fails all 3 packets)
OR
ping 8.8.8.8 source 192.16.24.1 interface wan1 (It fails all 3 packets)
OR
ping 8.8.8.8 source 192.16.24.1 interface eth2 (It fails all 3 packets) )eth2 is wan1 Interface)
0
All Replies
-
Hi @Gazoo271,
Welcome to Zyxel community.
Is this IP 192.16.24.1 FLEX200 wan interface I P? and it can be routed to Internet by your ISP?
EDIT:
BTW, it is unable ping to Internet from firewall internal interface IP.0
Categories
- All Categories
- 428 Beta Program
- 2.6K Nebula
- 163 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 348 USG FLEX H Series
- 291 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 261 Service & License
- 404 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.8K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 82 Security Highlight