Bring a NWA5123 back into USG management
Options
I deleted one of my NWA5123-AC access points from my USG controller by, Config -> Wireless -> AP Management -> Select the AP and click Remove.
After this the AP went into Standalone mode. How do I get it back into managed mode? It looks like the newer firmware no longer has the option to set the AP. I've tried using the reset button as well as flashing firmware.
After this the AP went into Standalone mode. How do I get it back into managed mode? It looks like the newer firmware no longer has the option to set the AP. I've tried using the reset button as well as flashing firmware.
0
Accepted Solution
-
I've solved this one... after a while the AP showed up as a rogue AP in the USG management. It was easy to adopt after that.0
All Replies
-
I've solved this one... after a while the AP showed up as a rogue AP in the USG management. It was easy to adopt after that.0
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 91 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 919 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 926 Nebula FAQ
- 422 Security FAQ
- 238 Switch FAQ
- 210 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight