GS1920-24HP console
Options
I have a GS1920-24HP that apparently lost its firmware and is stuck with the sys light flashing. I have a 4 pin console cable as there is a 4 pin console port on the right hand side of the switch. Is there something specific that I need to do to get console access to the switch? I read elsewhere for the pinout of the port, but I've not had any success at this point. Is there hope for the switch or is it just a brick at this point?
0
All Replies
-
@Zardoz,
The sys LED blinking is because the device fail to finish the booting process.
Could you please try to reset the switch to the factory default (by pressing the restore button).
If still not work, then please contact reseller for RMA.
Chris
0
Categories
- All Categories
- 396 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 86 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 915 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 419 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight