NXC2500 controller does not see dots NWA1123ACv3
Options
RDD123456
Posts: 1
in WirelessLAN
Hello. There is an NXC2500 Controller. Bought several NWA1123ACv3 points. Controller and points in one vlan. DHCP points receive from the controller. Option 138 on DHCP is enabled. The point is not visible from the web interface of the controller. What needs to be done so that the controller can see these points?
0
Accepted Solution
-
Hi @RDD123456
Welcome to Zyxel community!
NWA1123ACv3 can be used in standalone and Nebula mode only, not supported controller management such as NXC2500.
If you’d like to centrally manage device, you could consider using Nebula to get real-time network information and gain effortless control.
Thank you
Regards,
Bella
0
All Replies
-
AFAIK, at least LAN1 or LAN2 (as default configuration) connection between AP and the controller must be available to allow detection and configuration.
However: I (personally) do not know if NWA-1123ACv3 is manageable from NXC2500.0 -
Hi @RDD123456
Welcome to Zyxel community!
NWA1123ACv3 can be used in standalone and Nebula mode only, not supported controller management such as NXC2500.
If you’d like to centrally manage device, you could consider using Nebula to get real-time network information and gain effortless control.
Thank you
Regards,
Bella
0
Categories
- All Categories
- 383 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 76 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 894 Nebula FAQ
- 415 Security FAQ
- 233 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight