Cable diagnostics function XGS1930

Options
Alberto77
Alberto77 Posts: 6
First Anniversary First Comment
in Switch
Good morning,
I have tested cable diagnostics function on XGS1930 and i have found a strange result about Cable lenght result.
I have test a cable of about 1 m leght but the test function detect a lenght of 4 m.
I have repeated the test with a 15 m cable and the test result 22m.
If i repeat the test with the same cable the result doesn't change.
Why there is this different beetwen real lenght and mesaure lenght?

This is the example with 1 m cable:


Thanks 

All Replies

  • Zyxel_Chris
    Zyxel_Chris Posts: 660  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer
    Options
    @Alberto77,
    It's related to the cable quality and the peer device also affected, can you please unplug the peer side cable and test it again, please refer to the "Distance to fault" this time.
    Chris
  • HorstB
    HorstB Posts: 1
    First Comment
    Options
    There is a 65m CAT.7 cable between a GS1900-8HP and a GS1900-24E.
    The cable lengths in tech-support logfiles are 8HP: 75m, 24E: 95m 
    so I understand the length as an approach.

  • Alberto77
    Alberto77 Posts: 6
    First Anniversary First Comment
    Options
    I have made a test with cable disconnected:

    but the result is still wrong (the real lenght of the calbe is 1 m).
    I also try the 15 m cable:

    In this case the result is good.

  • Zyxel_Chris
    Zyxel_Chris Posts: 660  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer
    Options
    @Alberto77,
    The cable length will more accurate when it's up to 10 meters.
    Chris

Categories

Switch Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）