USG-110, exclude one specific ip-addresse from being written into the logfile.
firerabbit
Posts: 6
in Security
My Internet Service Providor has got some new fancy equipment to monitor their network. Unfortuatnly this equipment ping my ip-address every 15 seconds and hence make a line in the logfile 'ACCESS BLOCK' .
Is it possible to somehow exclude this specific ip-address - from where the ping comes - from being written into the logfile?
Thanks.
0
Accepted Solution
-
Hi @firerabbit,To allow ping from the IP of this equipment to USG110, you can create a new security policy rule.From: WAN, To: ZyWALL, Source: IP address of the equipment, Service: ping, Action: allow, Log: no0
All Replies
-
Hi @firerabbit,To allow ping from the IP of this equipment to USG110, you can create a new security policy rule.From: WAN, To: ZyWALL, Source: IP address of the equipment, Service: ping, Action: allow, Log: no0
-
Also, if you do not want to allow the ping request, the rule could look like this:
From: WAN, To: ZyWALL, Source: IP.address.of.equipment, Service: ping, Action: deny, Log: no
1
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight