ZyWall USG 40, Unable to upate to 4.73, Checksum Error
Options
I try to update a USG 40, from 4.72 (running) to 4.73.
The StandBy is V. 4.39.
Direct Update gives Error: Firmware update fail – checksum error, code: 400
Manual Update by FileUpload results in a reboot, but Update fails and version remains 4.72.
Do you have some more ideas? I have this problem on two devices.
The StandBy is V. 4.39.
Direct Update gives Error: Firmware update fail – checksum error, code: 400
Manual Update by FileUpload results in a reboot, but Update fails and version remains 4.72.
Do you have some more ideas? I have this problem on two devices.
0
All Replies
-
My USG40 updated fine...did you unzip the .bin file?
Could also be your StandBy is too old?1 -
@WebWorks the standby version is pretty... stale.
If you have 4.60/4.65 around you could do an update of the standby. Then update again to 4.73
Consider as precaution to reboot the device before trying to update and continue to use the 4.72 version until the standby goes to 4.73.1 -
Hi @WebWorks,
It could be firmware corruption in running partition.Please follow steps below to update firmware.(assume running partition is on partition 2)1) Backup partition 2(current running partition) startup configuration file.2) Reboot on partition 1.(Switch running partition from 2 to 1)3) Update firmware on partition 1.4) Apply 1) configuration file on partition 1.0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 923 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 212 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 1K Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 142 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight