snmp

Sinbadtiburon37
Sinbadtiburon37 Posts: 3
First Comment First Anniversary
in Switch

after firmware v480 the SNMP is disable?

All Replies

  • Zyxel_Judy
    Zyxel_Judy Posts: 1,627  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula

    Hi @Sinbadtiburon37 ,

    Hi @sinbadtiburon37,

    We would like to gather more information to assist you to solve the issue, so could you share with us:

    1. The model name
    2. The firmware version before you upgraded the firmware to V4.80
    3. The management mode: standalone mode or cloud mode
    4. The detail symptom like your switch is on standalone mode’s GUI, at first your SNMP is enable, however after you upgraded your switch to V4.80, the SNMP is disable? Or your switch is managed by Nebula, on the Nebla GUI, the SNMP is enable, however the SNMP tool is not work, ect.

    Judy

    Untitled Image

    See how you've made an impact in Zyxel Community this year! https://bit.ly/Your2024Moments_Community

  • Sinbadtiburon37
    Sinbadtiburon37 Posts: 3
    First Comment First Anniversary

    Hi, judy

    Model: XS1930-10

    Firmware before upgraded: 470

    Presen firmware 480

    It is standalone mode

    In the dashboard under Quik Link it show (SNMP STATUS) !s in red

  • Zyxel_Judy
    Zyxel_Judy Posts: 1,627  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    edited April 2023

    Hi @Sinbadtiburon37 ,

    You mention SNMP STATUS shows ! in red should look like the screen below. It is just a Security warning, not disable status.

    image.png

    The SNMP community is used for SNMP management and is set to public by default. To avoid security breach, please change the community string to a value other than default setting.

    If SNMP is enabled in W4.70, it will remain enabled after upgrading to 4.80. However, in W4.80, resetting to its default configuration will disable SNMP as our spec. In case, you'd like to enable SNMP, please go to Security > Access control > Service Access Control. Don't forget to change the SNMP community as well.

    Judy

    Untitled Image

    See how you've made an impact in Zyxel Community this year! https://bit.ly/Your2024Moments_Community

Categories

Switch Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）