Routing all traffic through a VPN tunnel.
I have 2 ZyWall 110's one at the main office the other at a remote. I have created a VPN tunnel from the remote office to the main office. How would I route all traffice from the remote site through the tunnel so that the main office gateway is used for all traffic from the remote site.
All Replies
-
On remote office, You can add all of your intranet IP segments as a group abject first.
And add policy route to route traffic to main office.
e.g. Source: IP Group, Destination: Any, Next Hop: VPN tunnelOf course, you have to add the same rule to route traffic back to remote office.
e.g. Source: Any, Destination: IP Group, Next Hop: VPN tunnel0 -
Hi @pgcoakley ,
Welcome to Zyxel community. 😀
You can follow this post to configure routing all traffic through a VPN tunnel.
0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 923 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 213 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 1K Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 142 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight