XGS2210-28HP Stacking
Freshman Member
Good afternoon
I have 2 XGS2210-28HP switches and I want to stack. The manual does not indicate whether it is possible to stack the specified switches in a ring (2 pairs of cables between each switch, i.e. SW1 ports 27, 28 are connected to ports 27, 28 of SW2).
It needs to be clarified:
- is it possible and correct to connect 2 switches with a pair of cables as in the photo;
- Will there be an increase in the exchange rate?
Accepted Solution
-
Hi @Smartqwerty,
This is unnormal, could you change the connecting DAC cable from port 27 to 28 and port 28 to 27? This is used to check if the problem is on the DAC cable or the switch port.
0
Zyxel Employee
All Replies
-
Hi @Smartqwerty,
Yes, you can connect in a ring.
But the exchange rate won't be increased since ports 27/28 are different stacking channels. When both ports are connected, one will be the main channel, and the other be the backup channel.
1 -
Good afternoon!
Thanks for the answer!When connected by a ring, the topology in the stacking menu in the switch interface is still indicated as a chain, not a ring. This is fine?
0 -
Sorry, I'll post the question again:
When connected by a ring, the topology in the stacking menu in the switch interface is still indicated as a chain, not a ring. This is fine?
0 -
Hi @Smartqwerty,
This is unnormal, could you change the connecting DAC cable from port 27 to 28 and port 28 to 27? This is used to check if the problem is on the DAC cable or the switch port.
0 -
Now works fine, thanks a lot!
1
Categories
- All Categories
- 415 Beta Program
- 2.3K Nebula
- 141 Nebula Ideas
- 94 Nebula Status and Incidents
- 5.5K Security
- 216 USG FLEX H Series
- 262 Security Ideas
- 1.4K Switch
- 71 Switch Ideas
- 1K Wireless
- 39 Wireless Ideas
- 6.3K Consumer Product
- 243 Service & License
- 382 News and Release
- 81 Security Advisories
- 27 Education Center
- 8 [Campaign] Zyxel Network Detective
- 3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 71 Security Highlight
