USG20-VPN
Hello,
My USG20-VPN no longer lets me log in at all. I've had the same password for 3 years now without issue.
The screen i go to for login has changed since last time…it now says Flex 50 instead of the old screen that said USG20-vpn. i've put several of these into service at various locations and they all still have the old screen to login and i can still login to them just fine….but this particular USG20-vpn has clearly been updated to a flex model…and my password no longer works.
please advise…i'd hate to have to blow it up to get back into it.
ike
Best Answers
-
Reset it load a backup config to it then change password
0 -
The answer was to reset it, but there were no backup profiles. Just the new update that changed it's entire gui from the old USG20-vpn to the new flex 50 gui.
0
All Replies
-
p.s. i tried to ssh into it, and it still rejected my password
0 -
Reset it load a backup config to it then change password
0 -
The answer was to reset it, but there were no backup profiles. Just the new update that changed it's entire gui from the old USG20-vpn to the new flex 50 gui.
0 -
USG20-VPN is renamed to USG FLEX 50 since version v5.20.
Did you fail to log in after upgrading the firmware? it could be your old password includes some special characters.BTW, I also suggest you backup the configuration regularly
0
Categories
- All Categories
- 395 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 82 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 914 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 415 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight