WAN to LAN only from specified Range

Options
valbuz99
valbuz99 Posts: 4 image  Freshman Member
First Comment First Anniversary
in Security

hi

on one location there isn't it possible to get a vpn. so i want to selective the allowed ip's for the access to my lan inside.

on my zywall USG50 i'm define a object (range) for that. but when i want to make the nat rule, there is no choice to select this object.

what im doing wrong here?

is there a FAQ or else?
thanks a lot
pat

Accepted Solution

  • PeterUK
    PeterUK Posts: 4,718 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    edited June 2023 Answer ✓
    Options

    You mean source IP range by NAT rule? I think the USG50 is too old to do that newer models can

    But what you can do is a policy control rule from WAN to LAN with source IP range

All Replies

  • PeterUK
    PeterUK Posts: 4,718 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    edited June 2023 Answer ✓
    Options

    You mean source IP range by NAT rule? I think the USG50 is too old to do that newer models can

    But what you can do is a policy control rule from WAN to LAN with source IP range

  • valbuz99
    valbuz99 Posts: 4 image  Freshman Member
    First Comment First Anniversary
    Options

    hi Peter.

    thanks for answer.

    ok, thats possible ;-)

    i try with the rule.

    thanks so much!

    pat

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）