How Do I convert a port to WAN2 in USG100Flex

dirodiro
dirodiro Posts: 6
First Comment First Anniversary
in Security

I need to connect 2 Wans, How can I convert a lan port to WAN?…,

thanks

Accepted Solution

  • mMontana
    mMontana Posts: 1,422  Guru Member
    50 Answers 1000 Comments Friend Collector Fifth Anniversary
    Answer ✓

    Configuration → Port → Port Role.

    image.png

    Row 1: LAN1
    Row 2: LAN2
    Row 3: DMZ
    Row 4: WAN

All Replies

  • mMontana
    mMontana Posts: 1,422  Guru Member
    50 Answers 1000 Comments Friend Collector Fifth Anniversary
    Answer ✓

    Configuration → Port → Port Role.

    image.png

    Row 1: LAN1
    Row 2: LAN2
    Row 3: DMZ
    Row 4: WAN

  • dirodiro
    dirodiro Posts: 6
    First Comment First Anniversary

    ok, Thank you,
    sn't it necessary to make a policy?

    ok, i define the port as WAN2 and connect the ISP to it,

    Then how do I load balance?
  • PeterUK
    PeterUK Posts: 3,693  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary
    edited August 2023

    The USG100Flex only has one Native untag WAN from what I can tell making P6 show as WAN does not change it type for internal to external for it to connect to a gateway.

    You can however add a VLAN to WAN base port for another external and you will need a switch to likely untag it to the internet.

  • mMontana
    mMontana Posts: 1,422  Guru Member
    50 Answers 1000 Comments Friend Collector Fifth Anniversary

    @dirodiro mr @Zyxel_Jeff decided that my post was the answer.
    Did help solve your problem?

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）