FLEX 700H Virtual interface on external interface
Hi
Is it not yet possible to create a virtual interface on an external WAN interface (ge1)?
Accepted Solution
-
just without :1
you first need to be in editing then
vrf main interface ethernet ge1 ipv4 address 192.168.254.1/29
then
commit
in a setup I did with it showed as working but could be some problems
1
All Replies
-
you can by SSH like
edit running
vrf main interface ethernet ge2 ipv4 address 192.168.254.1/29
commit
copy running startupBut when you change stuff in the UI it may not stick and has to be applied again and may be problems
1 -
I would like to create a secondary interface to my primary static WAN IP on ge1 as a virtual interface. This option is possible on the older Zyxel firewalls.
So the command should maybe be something like this:
vrf main interface ethernet ge1:1 ipv4 address 192.168.254.1/29
The above gives me an error using ssh. So i guess it's not possible at the moment?Anyway, i think i can overcome this by using one of my available WAN IP's as IP instead of interface in one of my VPN's……
0 -
just without :1
you first need to be in editing then
vrf main interface ethernet ge1 ipv4 address 192.168.254.1/29
then
commit
in a setup I did with it showed as working but could be some problems
1 -
Thanks Peter, it's seems to be working!
1
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 923 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 212 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 1K Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 142 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight