New added NAT rule don't work till you reboot USG FLEX 200H

PeterUK
PeterUK Posts: 3,983  Guru Member
100 Answers 2500 Comments Friend Collector Seventh Anniversary
edited April 2024 in USG FLEX H Series

USG FLEX 200H V1.20(ABWV.0)

Found this problem when trying to redone ports for Input Director by a gateway-less setup each NAT rule needed a reboot of the FLEX for it to work.

New added NAT rule don't work till you reboot.png

All Replies

  • Zyxel_Jeff
    Zyxel_Jeff Posts: 1,343  Zyxel Employee
    100 Answers 500 Comments Friend Collector Fourth Anniversary

    Hi @PeterUK

    Thank you for reporting this case to us. Please allow us to reproduce the issue and investigate it further. Thank you.

    image.png
  • ZdenekB
    ZdenekB Posts: 10  Freshman Member
    First Comment Sixth Anniversary 
    I have the same problem on the FLEX 500H - the new NAT rules do not work until I reboot the device
  • Zyxel_Jeff
    Zyxel_Jeff Posts: 1,343  Zyxel Employee
    100 Answers 500 Comments Friend Collector Fourth Anniversary

    Hi @ZdenekB

    May we know which firmware version you are currently using? If this issue recurs, could you please assist us by collecting the diag-info log (Maintenance > Diagnostics > Diagnostics > Click 'Collect Now') at that time. Thanks.

    image.png

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）