New added NAT rule don't work till you reboot USG FLEX 200H

PeterUK
Posts: 3,770
Guru Member





USG FLEX 200H V1.20(ABWV.0)
Found this problem when trying to redone ports for Input Director by a gateway-less setup each NAT rule needed a reboot of the FLEX for it to work.
0
All Replies
-
Hi @PeterUK
Thank you for reporting this case to us. Please allow us to reproduce the issue and investigate it further. Thank you.
0 -
I have the same problem on the FLEX 500H - the new NAT rules do not work until I reboot the device
0 -
Hi @ZdenekB
May we know which firmware version you are currently using? If this issue recurs, could you please assist us by collecting the diag-info log (Maintenance > Diagnostics > Diagnostics > Click 'Collect Now') at that time. Thanks.
0
Categories
- All Categories
- 431 Beta Program
- 2.6K Nebula
- 164 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 364 USG FLEX H Series
- 292 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 262 Service & License
- 407 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 83 Security Highlight