CANNOT ACCESS Network > NAT at all

JPElectron · June 12

via the web interface Network > NAT never loads, all I get is spinny circle.

tried command line, cannot figure out how to delete any NAT rules, where is the command reference to delete a rule?

Zyxel_Jeff · June 14

Please use the CLI "show config vrf main virtual-server rule" to check the current virtual-server rule, as shown below, the rule is named NAT.

usgflex100h> show config vrf main virtual-server rule
rule NAT
enabled true
interface ge1
source-ip any
original-ip address 10.214.48.38
map-to address 192.168.168.168
nat-1-1-map
false
..
nat-loopback
true
..
map-type any

If you want to remove the NAT rule, please refer to below CLIs:

usgflex100h> edit running
usgflex100h running config# del vrf main virtual-server rule NAT
usgflex100h running config# commit
Configuration committed.

Zyxel_Jeff · June 14

Please refer to below FAQ articles:

How to check the NAT rule using CLI for USG Flex H series models?

How to remove the NAT rule using CLI for USG Flex H series models?

CANNOT ACCESS Network > NAT at all

All Replies

Categories

Security Help Center