SNMP autodiscovery leads to several interfaces, which is which?
JPElectron
Posts: 8
in Security
I used PRTG to do an autodiscovery of a USG Flex 500, it made several sensors but how to know which one is tied to which port? vs. interface? vs. vlan? vs. zone?
lo, which I assume was loopback and not important to me so I deleted that sensor
eth_base
eth_base1
eth1
eth2
eth3
eth4
eth5
eth6
eth7
0
Accepted Solution
-
Please check the corresponding interface by CLI: debug system ip addr
0
Guru Member
All Replies
-
Please check the corresponding interface by CLI: debug system ip addr
0 -
Worked great - thank you!
0
Categories
- All Categories
- 439 Beta Program
- 2.7K Nebula
- 191 Nebula Ideas
- 121 Nebula Status and Incidents
- 6.2K Security
- 468 USG FLEX H Series
- 308 Security Ideas
- 1.6K Switch
- 82 Switch Ideas
- 1.3K Wireless
- 44 Wireless Ideas
- 6.8K Consumer Product
- 281 Service & License
- 441 News and Release
- 88 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 93 Security Highlight
