NWA 1123-AC-Pro: Wrong/ No WLAN-Access
Dear Zyxel Team,
I use an NWA 1123-AC-Pro with firmware version V6.28(0)/V2.4.
The AP is configured as standalone:
Fixed IP address, subnet…
I'm trying to establish a wireless connection via this AP. I use an iPhone for testing purposes.
I select the SSID of the AP on the iPhone and the iPhone asks for the network key. I then enter this and a connection tick appears in front of the SSID. But the iPhone's WiFi display doesn't show a connection! I'm not connected to the AP. If I look at the IP address that the iPhone received, it is an IP address outside of my network.
If I enter the correct IP address, subnet... manually on my iPhone, the connection to the AP is established and the iPhone can also connect to the Internet.
Which settings do I need to change in the NWA?
Thanks for your support
Accepted Solution
-
Hi @Peter_B,
NWA1123AC-PRO only supports bridge mode, it doesn't support NAT mode, so you need a DHCP server to assign IP addresses to your clients in your network. Therefore, you don't need to change in NWA1123AC-PRO, but you need to change your gateway/router if it supports the DHCP server function.
Zyxel Melen0
All Replies
-
Hi @Peter_B,
NWA1123AC-PRO only supports bridge mode, it doesn't support NAT mode, so you need a DHCP server to assign IP addresses to your clients in your network. Therefore, you don't need to change in NWA1123AC-PRO, but you need to change your gateway/router if it supports the DHCP server function.
Zyxel Melen0
Categories
- All Categories
- 440 Beta Program
- 2.9K Nebula
- 208 Nebula Ideas
- 127 Nebula Status and Incidents
- 6.4K Security
- 528 USG FLEX H Series
- 331 Security Ideas
- 1.7K Switch
- 84 Switch Ideas
- 1.3K Wireless
- 50 Wireless Ideas
- 6.9K Consumer Product
- 292 Service & License
- 462 News and Release
- 90 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.6K FAQ
- 34 Documents
- 86 About Community
- 99 Security Highlight
Zyxel Employee