Access a service with username and password
Hi All,
The user accesses the website like: www.xxxxx.com, but how to pass an username and password so that only this particular user can access the website?
Thanks in advance.
Peter
0
Accepted Solution
-
Hi,
Add HTTPs into the service group "Default_Allow_WAN_To_ZyWALL"
5
All Replies
-
Hi,
It's two step.
First, login to your USG https://xxx.xxx.xxx.xxx with the username & password.
You will get a login session page. Keep it open so that USG know the source IP address is bind to this username.
Then, open another new tab or new windows on browser to access the website behind USG.
0 -
Hi,Thanks for your reply.I have made some changes in the past so the USG210 is only accessible within a local network.Cannot figure out what I did, so a user cannot logon through internet.SYSTEM - WWW - HTTPS is set to 443 and is enabled.SYSTEM - WWW - HTTP is set to 8090 and is enabled.Cannot access the USG210 with http://xxx.xxx.xxx.xxx:8090 or https://xxx.xxx.xxx.xxx from a remote location.Anything else I should set?0
-
Hi,
Add HTTPs into the service group "Default_Allow_WAN_To_ZyWALL"
5
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight