ROUTING
Freshman Member
Good morning,
I have an ATP200 with a vlan/dmz to which I connected a NAS that must be reached on the external IPs of the two WANs for the services on ports 80 443 and 10001, I created the NAT rules and the security policies I needed, from outside it works correctly! If I try to reach the device on one of the public addresses of the WANs connected with a PC from the lan or the vlan, it is unreachable.
Which rule should I create?
Thanks
All Replies
-
Sounds like NAT loopback? make sure its enabled for your NAT rule.
You then need a policy rule from LAN1 to DMZ
0 -
loopback is active
i create policy, but not found internal
0 -
check logs for blocked traffic
0 -
I have no blocks in the log regarding this route
0 -
Disable the firewall for a quick check.
So to be clear you go from LAN2 to the WAN IP to loopback to DS1618v IP?
0 -
Do you mean disable security policies? It doesn't work anyway...
0 -
Does your ATP get the WAN IP's not rfc1918 IP's?
0
Guru Member
Categories
- All Categories
- 415 Beta Program
- 2.3K Nebula
- 142 Nebula Ideas
- 94 Nebula Status and Incidents
- 5.6K Security
- 235 USG FLEX H Series
- 267 Security Ideas
- 1.4K Switch
- 71 Switch Ideas
- 1K Wireless
- 40 Wireless Ideas
- 6.3K Consumer Product
- 246 Service & License
- 387 News and Release
- 82 Security Advisories
- 28 Education Center
- 9 [Campaign] Zyxel Network Detective
- 3.2K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 71 Security Highlight
