IPV6 VPN
Freshman Member
Accepted Solution
-
Hi @dathing89
Could you let us know which firewall model you're using?
If you're using a ZLD-based firewall (USG/USG FLEX/ATP), you can refer to this article for a step-by-step guide on configuring IPv6 IPSec VPN:
Kay
See how you've made an impact in Zyxel Community this year!
0
Zyxel Employee
All Replies
-
Hi @dathing89
Could you let us know which firewall model you're using?
If you're using a ZLD-based firewall (USG/USG FLEX/ATP), you can refer to this article for a step-by-step guide on configuring IPv6 IPSec VPN:
Kay
See how you've made an impact in Zyxel Community this year!
0 -
Hello,
Many thank's for your help !
We try to "mount" an ipsec VPN between 2 site over Starlink. This provider use CGNAT router, so 500 and 4500 port are not allowed.
But we discover that Starlink provide IPV6 IP without NAT…
Is it possible to create an IPV6 tunnel with IPV4 Lan on each side ?
Many thank's again
L.
0 -
0
-
Hi @dathing89
Using an IPv6 tunnel with IPv4 LANs on each side is technically feasible but not recommended due to potential routing issues. The separation between IPv4 and IPv6 stacks can make traffic management and routing complex.
Kay
See how you've made an impact in Zyxel Community this year!
1
Categories
- All Categories
- 415 Beta Program
- 2.4K Nebula
- 151 Nebula Ideas
- 98 Nebula Status and Incidents
- 5.7K Security
- 271 USG FLEX H Series
- 274 Security Ideas
- 1.4K Switch
- 74 Switch Ideas
- 1.1K Wireless
- 42 Wireless Ideas
- 6.4K Consumer Product
- 250 Service & License
- 389 News and Release
- 84 Security Advisories
- 29 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.6K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 74 Security Highlight
