Is it possible to show fiber optics info on XS1930-12HP?

peos42 · November 27

I have an old Netgear prosafe switch. On it I can run…

Is it possible to in some way show such info on this XS1930-12HP if moving these SFP+ units fromt the netgear to the zyxel switch? I have Access L3 license.

Thanks in advance

//Peo

Zyxel_Melen · 2:11AM

Hi @peos42,

Have you tried the command "show interface transceiver XX" I mentioned in another post? Below is the example result of the command:

Hope it helps.

Zyxel_Melen · 2:11AM

Hi @peos42,

Have you tried the command "show interface transceiver XX" I mentioned in another post? Below is the example result of the command:

Hope it helps.

peos42 · 11:12AM

I had not yet tested a real SFP+ when posting here… Just looked for the equivalent commands in the cli and the cli PDF… Sorry for that. Now I have added one physical fiber optics and one 10GbaseT SFP+, and indeed I see the info I am looking for with the "show interfaces transceiver NN"

Tnx and sorry for not trying that out before posting :)

Peo

Is it possible to show fiber optics info on XS1930-12HP?

Accepted Solution

All Replies

Categories

Switch Help Center