Static LAG VLAN membership

faktorqm
faktorqm Posts: 2  Freshman Member
in Switch

Hi there! I have a brand new XMG1915-18EP switch. I have 3 VLANS, users, guests and IoT. I set the port 17 and 18 as a static LAG with source and destination IP address protocol to another switch.

I want to do the following setup:

user vlan: untagged ports 11-15 and tagged on lag

guests vlan: untagged port 16 and tagged on lag

IoT vlan: untagged port 1-4 and tagged on lag (to take advantage of PoE)

I'm not able to find how to select the "normal", "fixed" and tx tagging options for the LAG. The name of the LAG is T1 but I'm not able to set the VLANs there.

Thank you! Regards!

All Replies

  • Zyxel_Kay
    Zyxel_Kay Posts: 1,201  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - WLAN Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security

    Hi @faktorqm

    Thank you for reaching out!

    To configure VLANs for your LAG (P17 and P18), ensure that the VLANs are tagged on these ports. The XMG1915-18EP does not require a separate interface for LAG VLAN configuration, so tagging the VLANs directly on the LAG ports should suffice.

    If you're experiencing issues with traffic not flowing as expected, please double-check the following:

    1. Ensure the same VLAN tagging is applied on the corresponding LAG ports of the other switch.
    2. Verify that both switches have identical LAG configurations, including the protocol and settings.

    If the issue persists, could you provide more details about the behaviour or any error messages you're encountering?

    Kay

    Untitled Image

    See how you've made an impact in Zyxel Community this year! https://bit.ly/Your2024Moments_Community

Categories

Switch Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）