Ghost interface not match up with config

PeterUK · January 11

V1.30(ABWV.1)ITS-24WK47-m6271

and on Ge4 it should have in the config
/ vrf "main" interface ethernet "ge4" ipv4 address "192.168.255.235/26"
/ vrf "main" interface ethernet "ge4" ipv4 address "192.168.255.253/26"

but only
/ vrf "main" interface ethernet "ge4" ipv4 address "192.168.255.235/26"
shows when config downloaded

yet if a upload that config with only
/ vrf "main" interface ethernet "ge4" ipv4 address "192.168.255.235/26"
I apply reboot then I have rules for 192.168.255.253 and they still work I ARP for 192.168.255.235 and 192.168.255.253 and its the FLEX H yet a config upload without
/ vrf "main" interface ethernet "ge4" ipv4 address "192.168.255.253/26"

So then I when to webconsole to add back
vrf main interface ethernet ge4 ipv4 address 192.168.255.253/26
commit
copy running startup

downloaded the config to check
/ vrf "main" interface ethernet "ge4" ipv4 address "192.168.255.253/26"
which it was but found the config file increased a bit from 311KB to 349KB
so got a TextCompare app and found some added lines of config like for VPN site to site along with other stuff but not sure why they got added? Maybe I was running V1.30(ABWV.1) with a setup that did not have them then updated firmware to V1.30(ABWV.1)ITS-24WK47-m6271 and the webconsole decided to add some new lines?

PeterUK · January 12

update

so not a Ghost but when I disabled DHCP options for Ge4 this removes added interfaces

/ vrf "main" interface ethernet "ge4" ipv4 address "192.168.255.253/26"

But as to why traffic like PoP going to 192.168.255.253 works is to do with NAT rules even if 192.168.255.253 interface is removed NAT acks as a interface for the IP and ARP reply for it.

PeterUK · January 13

Ok update this got fixed in V1.31 with the added Secondary IP box but sadly no way to do DHCP with Secondary IP box :(

Ghost interface not match up with config

All Replies

Categories

Security Help Center