VPN Forwarding not working
Options
IntelliSoft
Posts: 5
Hey
I am new with Zyxel Products.
I had a Netgear Firewall till yet. Behind my Firewall I have a Windows 2008R2 running a RAS Server (VPN)
It was not a Problem to connect with my VPN Server yet, but since my new Zyxel, it isn't working anymore...
What I did so far:
I created a Service Group and added the predefined Services:
Then I addes an address to my VPN Server:
And then I added a NAT
But the VPN can't connect
What am I doing wrong? - As I said, as I used the Netgear, everything was working fine.
I have other NAT's installed to connect to a service, this is working fine...
Hope someone can help me to identify the problem
THX
I am new with Zyxel Products.
I had a Netgear Firewall till yet. Behind my Firewall I have a Windows 2008R2 running a RAS Server (VPN)
It was not a Problem to connect with my VPN Server yet, but since my new Zyxel, it isn't working anymore...
What I did so far:
I created a Service Group and added the predefined Services:
Then I addes an address to my VPN Server:
And then I added a NAT
But the VPN can't connect
What am I doing wrong? - As I said, as I used the Netgear, everything was working fine.
I have other NAT's installed to connect to a service, this is working fine...
Hope someone can help me to identify the problem
THX
0
Accepted Solution
-
Seems, that I found the Problem.
On the NAT I have had to enable the NAT loopback Option - now everything works fine!
THX
0
All Replies
-
The firewall will not auto open for NAT mapping ports/protocol.
You need to add one security policy to allow the access,
From WAN ZONE to LAN ZONE,
Source: any, Destination: server IP address, Service: service group you use in NAT rule
Action: allow
0 -
Oh -sorry, yes I have this Policy already.
I have played around and I have renamed the service Group, because it had the same Name as the NAT entry. I thought, Maybe this could be the Problem, but it isn't...
I am running the program port query to check it, but it isn't working...
0 -
Seems, that I found the Problem.
On the NAT I have had to enable the NAT loopback Option - now everything works fine!
THX
0 -
Hi @IntelliSoftGood heard you found the reason of it.0
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.2K Security
- 93 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 921 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 938 Nebula FAQ
- 425 Security FAQ
- 238 Switch FAQ
- 210 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight