Slight confusion about interface "metric" setting
Options
Freshman Member
My understanding of the metric parameter is that assigning a higher number to an interface will cause the ZyWALL to give preference to similar interfaces with lower numbers when routing traffic. Do I have that correct?
In my particular situation, I would like the ZyWALL (310, V.4.33) to prefer our cable internet connection over our DSL connection. The "wan0" interface has a "metric" of "0", and the "tel_ppp" interface has a metric of "1". However, when I look in Maintenance > Packet Flow Explore > Direct Route, they both have "0" indicated. That's not correct, is it?
Thank you for helping me get a better grasp on the subject!
In my particular situation, I would like the ZyWALL (310, V.4.33) to prefer our cable internet connection over our DSL connection. The "wan0" interface has a "metric" of "0", and the "tel_ppp" interface has a metric of "1". However, when I look in Maintenance > Packet Flow Explore > Direct Route, they both have "0" indicated. That's not correct, is it?
Thank you for helping me get a better grasp on the subject!
0
Accepted Solution
-
Yes, same route with lower metric take higher priority.
The metric is for the default route of the interface.
So you need to check the "Main Route" table.5
Master Member
All Replies
-
Yes, same route with lower metric take higher priority.
The metric is for the default route of the interface.
So you need to check the "Main Route" table.5 -
True enough—thank you!0
Categories
- All Categories
- 439 Beta Program
- 2.8K Nebula
- 196 Nebula Ideas
- 123 Nebula Status and Incidents
- 6.3K Security
- 480 USG FLEX H Series
- 313 Security Ideas
- 1.6K Switch
- 83 Switch Ideas
- 1.3K Wireless
- 45 Wireless Ideas
- 6.8K Consumer Product
- 284 Service & License
- 450 News and Release
- 88 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 93 Security Highlight
