ATP200: no connection to gateway after automatic Firmware update (V5.41 to V5.42)

Options
wguenten
wguenten Posts: 6 image  Freshman Member
First Comment Fourth Anniversary
in Security

ATP200

Automatic Update from V5.41(ABFW.0) to V5.42(ABFW.0). Status OK.

But no connection to gateway is possible (fixed addresses ipv4 and ipv6).

After reboot with V5.41 the connection runs correctly.

Accepted Solution

  • wguenten
    wguenten Posts: 6 image  Freshman Member
    First Comment Fourth Anniversary
    Answer ✓

    Rebooting again with V5.42 → works correctly. Problem solved.

All Replies

  • wguenten
    wguenten Posts: 6 image  Freshman Member
    First Comment Fourth Anniversary
    Answer ✓

    Rebooting again with V5.42 → works correctly. Problem solved.

  • wguenten
    wguenten Posts: 6 image  Freshman Member
    First Comment Fourth Anniversary

    The problem is not solved:

    After a reboot with V5.42 the atp200 runs some time correctly. After a certain time (hours) the problem begins again.

    One app (cnlab) pointed to a DNS problem.

    After some reboots and one unexpected reboot: I go back to V5.41 and wait until a correct update is available.

  • PeterUK
    PeterUK Posts: 4,411 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary

    Do you have FQDN objects?

    https://community.zyxel.com/en/discussion/32312/v5-42-dns-is-broken-with-fqdn-objects#latest

  • wguenten
    wguenten Posts: 6 image  Freshman Member
    First Comment Fourth Anniversary

    Yes, I habe several FQDN objetcts, as well ipv4 and ipv6.

  • wguenten
    wguenten Posts: 6 image  Freshman Member
    First Comment Fourth Anniversary

    With updating to V5.42(ABFW.1) my problem is solved.

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）