How I can setup the DHCP on USG 1100. Firmware 4.33(AAPK.0)
I'm , new on the Zyxel world, I had almost a month try to make work the USG 1100, so far I was able to make the VPN connect but not traffic in and out then I notice that my DHCP is not leasing IP address to no one. If so one can help me to figure this out I will really appreciated.
All Replies
-
Hi @iojeda
In default configuration Ge3~Ge5 have enabled DHCP server function.
Configuration > Network > Interface > edit interface configuration setting.
According to VPN question, system will auto route traffic in the VPN tunnel when traffic SourceIP/DestinationIP are the same as LocalPolicy/Remote Policy in VPN setting.
Does your traffic has match to this condition?
0 -
Thanks for the answer the issue was the firmware, After reset to factory the DHCP start tu issue IP address.
0 -
Hi @iojeda
It's good to know the issue has resolved in your environment.😁
0
Categories
- 6.9K All Categories
- 2 Education Center
- 1.4K Nebula
- 34 Nebula Ideas
- 40 Nebula Status and Incidents
- 3.9K Security
- 203 Security Ideas
- 748 Switch
- 31 Switch Ideas
- 627 WirelessLAN
- 9 WLAN Ideas
- 4.6K Consumer Product
- 105 Service & License
- 223 News and Release
- 39 Security Advisories
- 520 FAQ
- 238 Nebula FAQ
- 120 Security FAQ
- 73 Switch FAQ
- 67 WirelessLAN FAQ
- 6 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 44 About Community
- 31 Security Highlight