Certain AP models feature both Uplink and LAN1 ports. These physical Ethernet ports on your AP serve to connect the AP to your network and other devices. This FAQ aims to provide a clear understanding of these two ports. Uplink port: The Uplink port is used to connect the AP to your network. This could be a connection to a…
For users who have the requirement to build up a network environment but lack the environmental condition to deploy cables in their scenarios Mesh is an option for users to enlarge the signal coverage via the wireless connection between APs. MESH on the APs managed by the controller, we called “ZyMesh”. There is the…
The example instructs how to set up AP group with load balance. There are three types for load balance, by station number, by traffic level, and by smart classroom. This example shows the configuration of these three kinds of load balance for different scenarios and the load balance is set per radio. Configure Load Balance…
The example instructs how to set up ZyMesh. When AP’s signal needs to extend, use ZyMesh to set up connection between root AP and repeater AP. Because ZyMesh profile makes the WDS connection, the root AP and repeater AP don’t need to use the same SSID for users connecting. Configure ZyMesh Profile 1 Both root AP and…
Procedure * Connect all APs to the switch through Ethernet cable * Go to CONFIGURATION > Network > IP Setting, and configure all the APs with static IP addresses. * Go to CONFIGURATION > Object > WDS Profile > WDS, and configure the WDS SSID. Also confirm the WDS SSID and Pre-Shared Key on all APs are the same. * (On root…
1. If you select As Native VLAN, the packets from the AP are untagged. Set management VLAN ID as 1 and select As Native VLAN. The console shows this AP is in VLAN 1 and untagged. 2. If As Native VLAN is not selected, the packets from the AP are tagged. Set management VLAN ID as 30 and clear the As Native VLAN checkbox. The…
There is no command or function to clear the DHCP pool when the pool is full. The nearest method would be to shorten the lease time and re-open the DHCP server or reboot the NXC. Re-opening the DHCP will interrupt the service for a while, but all the IPs will be released from the DHCP server. 1. Shorten the lease time. 2.…
If there are over two repeater APs connect the one root AP or the two hops of WDS link in your scenario, you can add the uplink AP's mac address manually to avoid repeater AP connect to the wrong AP. Scenario 1: Two repeater APs connect to the one root AP Scenario 2: Two hops of WDS link Access the uplink AP and check the…
The wireless load balancing function is designed to delay the responses to client probe requests when the AP is overloaded. New clients could eventually associate with the AP if there is no other AP to connect to or they always choose to connect to the same AP. The difference is enabling or disabling Disassociate station…
Yes, when the AP is set to repeater mode, the bridge mode is disabled by default. To enable bridging, select the option "Enable Wireless Bridging" when you set up a repeater AP. CONFIGURATION > Wireless > AP Management > Mgnt. AP List > Edit Note: The topology of wireless bridge LAN: At the time of writing, only the…
It looks like you're new here. Sign in or register to get started.