-
Router NBG-418N v2 ntp, syslog, telnet
Hello, I use the NBG in AP mode. I have had an intrusion problem in my LAN. I founded a brute force attack logged by the device. So i'm trying to secure a little. First I noticed time is wrong... time resets after reboot... it is not possible to set a NTP server, so i cannot try to match time in the (other) firewall…
-
Any experience with loosing WAN after appx 24hrs ?
Im have kind of bad luck or missing something badly, as between 24 and 48 hrs my Zyxel NBG 6615 basically says good bye to outside world, and I need either to restart it or hit 'Apply' button in Network>WAN>Internet Connection sub menu so it reconnects and again runs OK within mentioned time period. Running it on newest…
-
What is the maximum length of Ethernet cable support on NBG7815's 10G port?
For
10Gbps speed on 10G port of NBG7815, please make sure the Ethernet cable is Cat-6, Cat-6a, or Cat-7, and within the range of below information. Over the maximum length of each Ethernet type, the
performance of the connection may not be able to reach the rate of 10Gbps.
-
ZyXEL NBG4615 to repeater
Good day. This is my first post in Reddit. I want to use my ZyXEL router as a repeater because my ISP provided me with a router without a WAN Ethernet port. It's for fiber cable. So from my main router that takes fiber cable, I want to connect my ZyXEL router to extend signal. Any link or video you can recommend me to…
-
NBG6615 and external IP problem
Hi all!I've recently bought NBG6615, and I really like it. But I have a routing problem.The ISP gives me external IP in form 77.xxx.yyy.zzz. And I connect to their Microtik by static address like 192.168.88.2 gateway 192.168.88.1. The connects and pings are going just fine from any network, for example from my 4G phone,…
-
NBG6615 does not load after updating firmware
HelloNBG6615 does not load after updating the firmware. A message about the possibility of updating was waiting for a long time in the web interface. I downloaded new software, clicked update. The web interface has notified that the firmware has started. I waited about an hour, but the router did not boot. After rebooting,…
-
how to find ip adress of my router ?
I must change an old router and find the parameters but i don't know the ip adress. 192.168.1.1 dosen't work. #Home_Router_Jan_2020
-
Cannot see new Nano devices on my network Armor Z2
I bought 2 Nano devices to bridge network to detached garage. The radios talk to one another but I cannot see them on the Zyxel Armor Z2. Model nbg6817. I cannot find the access point within the Zyxel software. The Zyxel is not visable to my Nest G3 Thermostat either. It was connect but now has dropped and won't reconnect.…
-
ZyXEL NBG4615 Bricked after firmware upgrade
Hi can anyone help me how to fix a bricked Zyxel NBG4615. Thanks #Home_Router_Jan_2020
-
Zyxel NBG6616 bricked after firmware update
Hello! I tried to update my firmware, but for some mystical reason it failed. There was this timer (300sec) to wait and after that, it just said that update failed etc. After that I couldn't access my router settings, so I tried to reset the whole router. No my router isn't working at all, power is on at it shows that my…
-
ZyXEL Armor Z2 Firmware old
Is the router no longer maintained since there have
been no updates for a long time? #Home_Router_Dec_2019
-
NBG4115
Hi all!I know it's cheap, I know it's old, but I like it very much ;)However - after my attempt to upgrade the firmware it cannot start - only two leds (1 from power and the other for WIFI) are on and nothing happens. The firmware upgrade went smooth for KNL file. The router went dead after the second, APPS upgrade. I…
-
How to disable these ports on the router NBG-418N v2?
I check open ports with this command: nmap -Pn -p 1-10000 192.168.1.1Displays the following:23/tcp open telnet 80/tcp open http 5431/tcp open park-agentHow do I close ports 23 and 5431? I disabled upnp in the settings, but port 5431 remains open, which does not give me the necessary security #Home_Router_Dec_2019
-
NBG6515 makes trouble when sending Emails with attachement(s)
My NBG6515 workes all fine, but last months many Emails with one ore more attachements are not sent. The error notice gives notice: Time Out... I think that this is a problem caused by the NBG6515 because on other networks all runs fine. I didn't change the configuration since starting the NBG6515 three years ago. It is…
-
Time restriction on additional WLAN?
Greetings! I am looking for a wifi router which can make a second wireless networkand set a time restrictions for every weekday on it. Could you tell me if it is possible withe the Zyxel routers?If yes, please suggest routers models that I should look at. Thanks much! #Home_Router_Dec_2019
-
Armor Z2 signal loss
Dear all The problem : the router loses the signal for a short time. I checked all possible options - wan connection, updated the firmware, make ping test from the router and have - network is unreachable ! ...etc.\I also tested the network on other routers and everything working well.In the process of opersaion, the…
-
Use NBG6604 as wifi extender
As the title mentioned, is this possible? Thanks in advance. #Home_Router_Nov_2019
-
ZyXEL NBG-418N V2 - bricked
Hi , I have a ZyXEL NBG-418N V2 and for one year was good , after that it started to disconnect by it self from the internet causing the loss of the wireless , I had to reboot the device everytime it did that , at some point was so frequently that is just put it somewhere for over a year or so ... I'm using my old wireless…
-
NBG6515 Port forwarding/NAT
Hey, I'm trying to set up nat/port forwarding on my NBG6515 router. I managed to open port 22 (for SSH) and forward it to my server computer running in my LAN. So: ssh username@extIP works and directs ssh to my home server. However, I was unable to map the routing between different ports, how can I do that with my router?…
-
Aurora - does it upload the videos to the cloud? How to access?
Hi,I have two Auroras set up and running. Videos are in the playlist, but ONLY if the camera is online. So I assume it has a 16GB internal storage (The technical description leave it open if it is internal or in the cloud). My aim is to store the videos in the cloud. I mean would be pretty useless if a thief sees the cam…