-
FWA510 keeps going offline and needs rebooting since last FW update
Hi, I have this FWA510 rooter since 1,5 years, had been working fine.. Since last firmware update keeps loosing connection, goes offline and needs rebooting. It somethimes does once a week other times each day.. any help out there? 🙄
-
LTE5398-M904 support CLI?
Hello. I have a Zyxel 4G LTE-A indoor Router LTE5398-M904 with firmware V1.00(ABQV.4)C0. Tell me, does it support a Command Line Interface (CLI)? If it does, where can I find a list of supported commands?
-
NR7102 Firmware
I have bought this second hand (new in box) It has some limited vendor firmware that does not have the /Upgrade Firmware section in the menu. How do i put the zyxel firmware on this device? thank you
-
NR7101 disconnects from LAN on regular base
My NR7101 was running fine for the last two years. But since about 2 weeks the NR loses the LAN connection almost every day for about 2 hours. The IP address of the NR is dead and is giving no response and of course also no internet connection during this time. After about 2 hours the lan connection to the NR is “waking…
-
Missing IPv6 prefix on NR7102 passthrough
Trying to use a NR7102 (firmware V1.00(ABYD.3)C0) as a 5G connection for an OpenWrt router. Router only gets two IPv6 adresses, one full adddres and one <prefix>::2. No PD, only local gateway. NR7102 is in passthrough mode. I can see the prefix in the System info, but it is not passed over to the OpenWrt router. Any hints?
-
NR7101 nslookup works but ping doesn't and I can't browse the internet
Hi all, I have been struggling to get my NR7101 working again. When it was working it was in router mode using manual apn settings. Then it just stopped working. * I thought maybe it was a windows update, so I rolled that back, then I reset the pc entirely. * I also reset the NR7101 to factory. but it still doesn't work. *…
-
NR2102 - sim not ready / illegal
Getting commonly discussed and never resolved problem with nr2101. Spent hours debugging with firmware update and factory reset. Sim works perfect in iPhone. seems to be a common problem with all the postings since 2020…not cool for a 300 euro device 2 years old :-( and support never posted a solution. I want my money back!
-
Zyxel LTE5398-M904 remote reboot
Hello everyone, i have this rooter at my country house. I have a problem, i use this to access my cameras to make sure everything is ok at the house. Problem is i do have connection for like 3 or 4 weeks and then i loose connection for a few days. Again on its own after a few days , i do have connection again. It is not…
-
FWA505 USB port file system compliance
Hi, I have tried to connect pen drives or HD drives but none (except FAT32) is recognized. I need to understand if my unit has a problem. Best regards
-
Odd NR7101 Cell Info
Does anyone have any ideas what is going on here. For context, I've been using the NR7101 for about 15 months and 5G NSA became available about 9 months ago. Cell info has always looked normal, with 3-4 channels aggregating (B3+B3+B20+NR1). B20 sometimes disappears, so I consider that normal behavior. Now yesterday we had…
-
Using a Wavlink AP
Have a LTE7490-M904 which works fine. I am now wanting to add a Wavlink AC600 wifi extender configured as an AP. I use an unmanaged switch which seems to work fine. Problem I cannot get the AC600 to access the interent. Have spoken to Wavlink who are useless. The AC600 works fine when connected to another network I have…
-
LTE 7490 NOT WORKING WITH SWITCH OR AP
Hi, i have recently set up the out door 4g router and i get a good 100mbps out the cable but when i put it into my ubiquiti switch or ap, i get nothing. i no the unifi stuff is working as i have checked it on my network at home
-
LTE7490-M904 - is it possible to monitor data usage?
I'm using an LTE-7490-M904 with an EE Sim card supplied by Scancom here in the UK. It's a bulk data unlimited usage SIM, which with EE has a fair usage limit of 600gb. I've been averaging around 450-500gb over the past few months with a different provider who did allow monitoring, but whose speeds were often poor. There is…
-
Strange Pci Scan nr7101
Anyone else having the same weirdness with Pci Scan? It has always been the reverse order at MNC and MCC, but when the error is finally corrected, the incorrect remains. This oddity is similar on 100ABUV10CO and 116ACCC1CO. Why @Zyxel_Kay
-
NR5101
Login first time works, after changing password it does not workanymore
-
LTE2566-M634 AUTO-Turn on without pressing the power-button
I would like the router to start automatically as soon as I charge the battery without having to press the power button. Background: The router is connected to the USB in the car and should be switched on permanently without having to press the button after the battery has run out and is then charged again.
-
NP2101: internal IP addresses
How or where can I see which device has been assigned which internal IP address in the NP2101? I would like to access one device from another in the internal network and would need the IP address for this.
-
Difference NR5103 vs. FWA510
Dear all My NR5103 which is sold to non-business retail customers through various retail channels in Switzerland without any ISP connection unfortunately is not receiving any support from Zyxel as Zyxel support claimed this being an "ISP only" sold product (which is not the case in Switzerland, but anyway…). As a…
-
FWA710 - get information about LTE signal via webapi or ssh
Hi, Is there any possibility to get information about LTE cell info ( RSSI, etc… ) via SSH, SNMP or web api for Zyxel FWA710 ?
-
Lte7240-M403 How to reboot by ssh or telnet
Hello, guys! How can i remote reboot this thing using ssh/telnet? I've already try 'sys reboot', 'zycli sys reboot', 'reload', 'restart', but nothing works=( I'm use Windows 10 Telnet and Putty and no result=( #SP_Feb_2020