-
ONE NODE ALQAYS SAYS MOVE IT CLOSER
There is one node that always asks me to move it closer to the primary one. I brought it within 5 metres of the primary and even then it says move it closer. Why is this happening. I dont know where to place it. Please help. Thanks. ! Cyrus !
-
I cant upgrade vmg3312-t20a
I bought this yesterday. Firmware version is V5.30(ABFX.5)G0. I couldnt find anything about that G but website has an update named V5.30(ABFX.5)C0. First what is the difference and do i need to upgrade,second i tried to upgrade but it says Image uploading failed. You may press 'Cancel' to upload another firmware image…
-
Any known issues with the ZyXEL P-660R modem?
Hello! I'm currently subscribed to TekSavvy's 10Mbps 400Gb DSL plan and every time I launch a heavy download, I'd say roughly 2Gb or more, my internet goes down after a few minutes. Only way I've found to make it work again is to unplug the modem, leave it unplugged for a minute or two then plug it back in and let it…
-
How can I schedule a regular reboot on my VMG4825-B10A?
I need to set the ZyXEL VMG4825-B10A to reboot regularly, ideally daily. I don't mind using the script technique (configure terminal, reboot) and running that using 'schedule-run 1 reboot.zysh daily 03:00' per the KB article at https://kb.zyxel.com/KB/searchArticle!gwsViewDetail.action?articleOid=012080&lang=EN, but there…
-
Flashing ZyXEL WAP3205 v1, U-Boot doesn’t prompt
I am trying to flash my old ZyXEL WAP3205 v1 via serial. Connected to serial interface (using USB to TTL Serial Cable) and connected with Putty. As far as I know It should prompt me for selection: Please choose the operation: 1: Load system code to SDRAM via TFTP. 2: Load system code then write to Flash via TFTP. 3: Boot…
-
PLA6456 vs PLA5456 Powerline Adapters
I have a couple questions on these products. Would there be much of a real world speed difference between these two products? By the advertisement there is only 400 Mbps difference between the two products, but one advertises G.hn Wave 2 and the other advertises HomePlug AV2. Could the two be used together? #PLA_Jan_2020
-
PLA5456 AV2000 HomePlug AV2 Powerline
Hi, does the Powerline 2000 support Ethernet Jumbo Frames? And if so, what is the maximum frame size supported? Thanks!!!
-
Looking for a SOHO-Router
Hi,can anyone recommend me a router from the KMU series. At least I need:- VPN- VLAN- enough performance to process a 400MBit DSL line - with enough performance to upgrade to 1G.- run 2 DSL-Providers at the same time (Telekom + Deutsche Glasfaser).- Firewall- IPV4/IPV6- several LAN Networks (different IP-Address ranges…
-
Admin in Zyxel P660HTW2 EE
I have tray lo login to admin-interface of "Zyxel P660HTW2 EE", but i get only "Status". I did to reset it and i has set ip-adress as static 192.168.1.35, but not get admin-panel - only status-panel. How to do this?
-
zyxel keenetic lite
Hello! I'm using your company's router(zyxel keenetic lite) and I forgot my password, but I can not reset the router configuration, I changed the password and I forgot it. the reset button is broken. help me reset my password and username
-
WPA3 Support
I just got 2 new laptops. In setting up wireless security I got a message telling me my system was not secure because it didn't us WPA3. My C3000Z modem supports up to WPA2.Q1: When might this be an issue i.e. must I buy new hardware?Q2: Will ZYXEL issue a software upgrade to support WPA3?
-
How can I transfer my server with ZyXel?
I know how to do it, but what should I type in all the boxes. There is the start port, the end port, the translation start port, and the translation end port. What should I type in these boxes?
-
AMG1202-T10B Firmware
Hi Dear Support I am using AMG1202-T10B Modem & because of problem in GUI local panel, i hope after upgrading to the latest firmware, this problem will solve.
-
[vmg3006] dsl modem dhcp server => off
- How can I turn off the DHCP server in the dsl modem zyxel vmg3006? - How can I change the LAN address of my vmg3006 192.168.100.1 to another one? Thanks!
-
Troubleshooting Powerline with no lit in power on Led (PLA4211)
Hi everyone I hope sombody have some input due to I resent setup my old PLA4211 running from router to my garage (Utility software ver.7.0.6.17.0926 & My PC runs Windows 10 pro, 64bit). It worked fine with ping 10ms Dowload 80-95MBps upload was also quite good 30-35MBps. Normaly I have a connecton aprox 165MBps/35Mps. Just…
-
Zyxel PLA5456 powerline ethernet kit question
I just got this powerline ethernet kit used from a friend. I'm wondering if there are any firmware updates available for it that I need to download?
-
VMG1312-T20B Takoy madel ne sushestvuyut ne magu nayti
azizbek
-
Sim Not Ready Zyxel 3310
Hello, Hope someone can help. I have been using a TP link router with my three SIM card and it works perfectly fine. I wanted a router that can bridge which is why I purchased the Zyxel. I place my Sim in a brand new Zyxel 3310 then turn it on, wait 10 minutes and still get the flashing red light with the three signal bars…
-
LTE3316-M604 wat is wrong
Have 3 computers connected to Wi-Fi 5GHz and 3 computers connected
to Wi-Fi 2.4GHz. I can reach from 5GHz to 2.4GHz v.v. including file- and printer sharing
but NOT ALL. I configure dynamic route, nothing helps. Strange is that from a certain
computer the name appears in the explorer but can’t reach them; either with…
-
Is there any history of VMG3925-B10B self rebooting
As the title says, is there any history of VMG3925-B10B self rebooting, router has V13 firmware but it sees to want to reboot maybe after about a month. Router is on a UPS so its not power down. Thanks #SP_Oct_2019
