USG 310 hosts real time bandwidth
Options
Accepted Solution
-
Hi @Briz,
It’s not real-time bandwidth usage. It does not support real-time bandwidth usage on specific IP at current design.
In the Traffic statistics and Session monitor are accumulated bandwidth usage. You can get the highest bandwidth usage by clear/flush data to get latest accumulated bandwidth usage.
Want a FREE Access Point? Participate in our campaign and share your network setup for a chance to win!
0
All Replies
-
In traffic statistics and interface lan1 by host IP you can see the amount used for Tx/Rx0
-
Hi @Briz,
It’s not real-time bandwidth usage. It does not support real-time bandwidth usage on specific IP at current design.
In the Traffic statistics and Session monitor are accumulated bandwidth usage. You can get the highest bandwidth usage by clear/flush data to get latest accumulated bandwidth usage.
Want a FREE Access Point? Participate in our campaign and share your network setup for a chance to win!
0 -
ok thanks, do you plan to add this important information in the near future?
0 -
Hi @Briz,
Thanks for valuable suggestion and we will evaluate it in the future if it is beneficial.
This topic has been move to idea section :
https://community.zyxel.com/en/discussion/10636/real-time-bandwidth-usage-base-on-ip-address#latest
Want a FREE Access Point? Participate in our campaign and share your network setup for a chance to win!
0
Categories
- All Categories
- 413 Beta Program
- 2.3K Nebula
- 192 Nebula Ideas
- 87 Nebula Status and Incidents
- 5.3K Security
- 142 USG FLEX H Series
- 253 Security Ideas
- 1.3K Switch
- 75 Switch Ideas
- 993 Wireless
- 51 Wireless Ideas
- 6.1K Consumer Product
- 231 Service & License
- 362 News and Release
- 74 Security Advisories
- 23 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.6K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 101 About Community
- 67 Security Highlight