USG 310 hosts real time bandwidth
Options
Accepted Solution
-
Hi @Briz,
It’s not real-time bandwidth usage. It does not support real-time bandwidth usage on specific IP at current design.
In the Traffic statistics and Session monitor are accumulated bandwidth usage. You can get the highest bandwidth usage by clear/flush data to get latest accumulated bandwidth usage.
0
All Replies
-
In traffic statistics and interface lan1 by host IP you can see the amount used for Tx/Rx0
-
Hi @Briz,
It’s not real-time bandwidth usage. It does not support real-time bandwidth usage on specific IP at current design.
In the Traffic statistics and Session monitor are accumulated bandwidth usage. You can get the highest bandwidth usage by clear/flush data to get latest accumulated bandwidth usage.
0 -
ok thanks, do you plan to add this important information in the near future?
0 -
Hi @Briz,
Thanks for valuable suggestion and we will evaluate it in the future if it is beneficial.

This topic has been move to idea section :
https://community.zyxel.com/en/discussion/10636/real-time-bandwidth-usage-base-on-ip-address#latest
0
Categories
- All Categories
- 442 Beta Program
- 3K Nebula
- 230 Nebula Ideas
- 131 Nebula Status and Incidents
- 6.6K Security
- 667 USG FLEX H Series
- 359 Security Ideas
- 1.8K Switch
- 86 Switch Ideas
- 1.4K Wireless
- 56 Wireless Ideas
- 7.1K Consumer Product
- 307 Service & License
- 499 News and Release
- 96 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 5K FAQ
- 34 Documents
- 89 About Community
- 111 Security Highlight
Freshman Member
Zyxel Employee
Guru Member