[NEBULA] Multiple WAN configuration

Januzki
Januzki Posts: 2  Freshman Member
Second Anniversary
edited April 2021 in Nebula
Hi,
Is it possible to configure WAN ports so that all traffic goes to primary WAN and if it is down all traffic goes to secondary WAN?

All Replies

  • Zyxel_Barney
    Zyxel_Barney Posts: 84  Zyxel Employee
    Zyxel Certified Network Engineer Vertical - Education Zyxel Certified Network Engineer Vertical - MSP Zyxel Certified Network Engineer Vertical - HORECA Zyxel Certified Network Engineer Vertical - Elite
    edited April 2018
    Hello @Januzki

    Apologies for the late reply!

    The NSG currently only supports an active-active type failover.
    Wherein the NSG uses both WAN interfaces to distribute traffic to the Internet when both WAN interfaces are up, while routing across a single interface should any of the other WAN interface goes down.

    But to answer your question,  I would like to invite you to post it in our Idea Section or let us do so. We will evaluate the feasibility and then get back to you.   


    Best regards,
    Barney Gregorio
  • TCL_Support
    TCL_Support Posts: 8  Freshman Member
    Fourth Anniversary Nebula Gratitude Ideas master First Comment
    This is a desperately needed feature since policy routing is also unavaiable.
  • CrazyTacos
    CrazyTacos Posts: 53  Ally Member
    Fifth Anniversary First Answer Friend Collector First Comment
    But isn't an active-passive type fail-over solution obsolete if you already have an active-active type fail-over?
    It even looks like NSG has the option to set rate limits per WAN port.

Nebula Tips & Tricks