NSG100 Failover Wan 2 ?
Options
Headmaster
Posts: 8
Freshman Member
Freshman Member
in Nebula
Is it possible to config the NSG100 internet connection to Failover to another router with adls/fibre by using WAN2 P2 ? Our main connection is on Wan 1 P1. Any advice or docs would be appreciated, thanks.
0
Best Answers
-
Hi @Headmaster,
Yes, you may configure internet connection to Failover by using WAN2 P2.
Please setup your PPPOE/Static IP setting for WAN2 interface on WEB GUI and then go to Nebula menu security gateway > configure > Traffic shaping to set WAN load balancing algorithm to "Failover" and prefer WAN set "WAN1".
Below is the example:
Hope it helps.Zyxel Melen0 -
Thank you Melen!0
All Replies
-
Hi @Headmaster,
Yes, you may configure internet connection to Failover by using WAN2 P2.
Please setup your PPPOE/Static IP setting for WAN2 interface on WEB GUI and then go to Nebula menu security gateway > configure > Traffic shaping to set WAN load balancing algorithm to "Failover" and prefer WAN set "WAN1".
Below is the example:
Hope it helps.Zyxel Melen0 -
Thank you Melen!0
Categories
- All Categories
- 442 Beta Program
- 3K Nebula
- 231 Nebula Ideas
- 131 Nebula Status and Incidents
- 6.6K Security
- 680 USG FLEX H Series
- 362 Security Ideas
- 1.8K Switch
- 87 Switch Ideas
- 1.4K Wireless
- 56 Wireless Ideas
- 7.1K Consumer Product
- 309 Service & License
- 502 News and Release
- 96 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 5.1K FAQ
- 34 Documents
- 89 About Community
- 111 Security Highlight
Zyxel Employee