Adopt to Nebula remotely
Is it possible to adopt ATP200 to Nebula remotely? I am able to go through the process of applying the default-config to the ATP200, but when using the Nebula link, it states that I need to physically press the reset button as the firewall is not in the default state. Perhaps there is a CLI command I can run via SSH instead?
0
Accepted Solution
-
Hi @TAPTech,Reset the device to factory default settingsAdministrator must locally apply factory default settings by pressing reset button of firewall panel before switching to cloud mode. Only the following settings may be changed and still allow firewall to switch to cloud mode:1. Default admin account’s password2. WAN settings0
Categories
- 7.8K All Categories
- 1.6K Nebula
- 53 Nebula Ideas
- 53 Nebula Status and Incidents
- 4.3K Security
- 215 Security Ideas
- 906 Switch
- 40 Switch Ideas
- 803 WirelessLAN
- 15 WLAN Ideas
- 5K Consumer Product
- 131 Service & License
- 260 News and Release
- 49 Security Advisories
- 6 Education Center
- 573 FAQ
- 273 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- Documents
- 34 Nebula Monthly Express
- 67 About Community
- 40 Security Highlight