Adopt to Nebula remotely
Master Member
Is it possible to adopt ATP200 to Nebula remotely? I am able to go through the process of applying the default-config to the ATP200, but when using the Nebula link, it states that I need to physically press the reset button as the firewall is not in the default state. Perhaps there is a CLI command I can run via SSH instead?
0
Accepted Solution
-
Hi @TAPTech,Reset the device to factory default settingsAdministrator must locally apply factory default settings by pressing reset button of firewall panel before switching to cloud mode. Only the following settings may be changed and still allow firewall to switch to cloud mode:1. Default admin account’s password2. WAN settings
Click this link to start: https://bit.ly/3R2Wx52
Emily0
Zyxel Employee
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
