Router model EMG2926: How to open ports

Ali2
Posts: 2
in Home Router
Home hosting setup need open All ports in this picture. Where in my Xytel EMG2926 control panels can i do this?

0
All Replies
-
My Xytel panel (French)0
-
If there has any function you would like to config but it doesn't show on the GUI under your current access privilege, you could try to contact your local ISP they may help you to check it.
0 -
Bonjour @Ali2
There is a user guide manual for EMG2926-Q10A router at https://fccid.io/pdf.php?id=2197013
Section 14.3 talks about how to set-up Port Forwarding, under the Network->NAT part of the firmware.
Réseau -> NAT
I hope that this is helpful.
Kind regards,
Tony0
Categories
- 6.9K All Categories
- 2 Education Center
- 1.4K Nebula
- 34 Nebula Ideas
- 40 Nebula Status and Incidents
- 3.9K Security
- 203 Security Ideas
- 753 Switch
- 31 Switch Ideas
- 638 WirelessLAN
- 10 WLAN Ideas
- 4.6K Consumer Product
- 105 Service & License
- 224 News and Release
- 39 Security Advisories
- 522 FAQ
- 239 Nebula FAQ
- 121 Security FAQ
- 73 Switch FAQ
- 67 WirelessLAN FAQ
- 6 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 45 About Community
- 32 Security Highlight
Consumer Product Help Center
