ZyWALL USG 100 Firmware restore via FTP failed!!!
Options
These days I tried to update the firmware via FTP, and then the device cannot be started, I connected the serial port, and the following information is displayed.
I update the firmware according to the prompt FTP connection, and then it keeps saying that it failed, I don't know what to do.I was writing this question and suddenly realized that I used the firmware of the usg100-plus on the usg100. Well, it seems I can't figure it out.
0
All Replies
-
Hi @Bob_1,
Welcome to Zyxel community. In the process of firmware recovery, if you find the error messages "extract_fw_info: Fail = 255" on console, you may check Windows Firewall settings and disable Windows Firewall temporarily on your laptop.
Ref: https://community.zyxel.com/en/discussion/12943/recovery-steps-for-usg-flex-atp-series-application-patrol-signature-issue/p10
Categories
- All Categories
- 396 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 87 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 917 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 419 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight