[NEBULA] Site-to-Site VPN. Two NSG50 connected and tunnel established but now what?
Options
I have two NSG50 units for a headquarters and branch1. I've established a site-to-site vpn using Nebula. Able to ping headquarters Gateway, AP, and printers on site. Able to access web-interfaces for printers. Was not able to ping target PC at headquarters. Not able to see shared network resources under Network on branch1 PC. What step(s) am I missing in Windows to make this work? Creating security policies and generating certificates?
0
Comments
-
Have you disable the firewall rule on windows? Maybe that's why there is no respond.
As I recall, you cannot find the shared folder in the network neighborhood, since their VPN tunnel doesn't allow broadcast traffic pass through the tunnel.
You can try to access via IP directly.2 -
If I disable the private network firewall I can ping each target PC, map network drives and printers by their IP address. Resolved!
0 -
Categories
- All Categories
- 413 Beta Program
- 2.3K Nebula
- 192 Nebula Ideas
- 87 Nebula Status and Incidents
- 5.3K Security
- 142 USG FLEX H Series
- 253 Security Ideas
- 1.3K Switch
- 75 Switch Ideas
- 993 Wireless
- 51 Wireless Ideas
- 6.1K Consumer Product
- 231 Service & License
- 362 News and Release
- 74 Security Advisories
- 23 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.6K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 101 About Community
- 67 Security Highlight