FAILED: "Send Installation File To Installer" from Nebula
I setup the initial parameters (WAN, DNS, etc) of my USG FLEX 100 via the Nebula portal. I then selected the "Send Installation File to installer" option for the firewall config. After about 10 minutes, the screen on the Nebula portal was still spinning.
I can NOT see an option to download this file from the portal. If it's there, where? If not, any suggestions or do I just need to configure myself?
0
All Replies
-
Hi @PaulS,
Welcome to Zyxel community. Please send me org and site name in PM.
We would like to check if there is something wrong in Nebula.
0 -
BTW, did you receive mail from Nebula when you click resend?
0
Categories
- All Categories
- 415 Beta Program
- 2.3K Nebula
- 141 Nebula Ideas
- 94 Nebula Status and Incidents
- 5.5K Security
- 216 USG FLEX H Series
- 262 Security Ideas
- 1.4K Switch
- 71 Switch Ideas
- 1K Wireless
- 39 Wireless Ideas
- 6.3K Consumer Product
- 243 Service & License
- 382 News and Release
- 81 Security Advisories
- 27 Education Center
- 8 [Campaign] Zyxel Network Detective
- 3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 71 Security Highlight