NWA1100-NH

I am trying to set up an old NWA1100-NH but couldn't access web configurator even after reset. Please help.  Thank you.

All Replies

  • mMontana
    mMontana Posts: 764  Guru Member
    Which version of firmware do you have?
    Are you trying to access via HTTP or HTTPS? Did you read the default ip address? Have you a DHCP server on your network?
  • NewledgeDee
    NewledgeDee Posts: 2
    tried both - no success.  default ip address - no success.  no idea about DHCP server but my guess is no as it is connected straight to a router from a broadband supplier.  please help.  thank you.
  • tonygibbs16
    tonygibbs16 Posts: 384  Master Member
    edited July 4
    Hello @NewledgeDee

    Looking at the user guide at https://download.zyxel.com/NWA1100-NH/user_guide/NWA1100-NH_v2_ed1.pdf the default IP address is 192.168.1.2 

    The quick start guide see https://download.zyxel.com/NWA1100-NH/quick_start_guide/NWA1100-NH_001.pdf should help you make an Ethernet connection to the NWA1100-NH for configuration.

    The troubleshooting section of the talks about that the NWA1100-NH might be getting its IP address from a DHCP server, which in your case could the router from your broadband supplier.

    It might be worth trying to disconnect the NWA1100-NH from your router, and then doing a factory reset to see if you can ping the NWA1100-NH on 192.168.1.2 IP address.

    If you can ping it on 192.168.1.2 then you should be able to access the web configurator with a web browser (the user guide does not say that it is https) so just try putting 192.168.1.2 in the address bar
          - if you get the login screen then admin with password 1234 should give you access.

    I hope that this is helpful.

    Kind regards,
          Tony

Consumer Product Help Center