By the way, you can take a look at this post to know more about establishing Mesh link on Standalone mode: What is the procedure to construct the WDS between the standalone APs? — Zyxel Community
NWA55AXE - Radio 1 sets to repeater mode (2.4GHz) but grayed-out for Radio 2
Options
MShorty
Posts: 6
in WirelessLAN
I cannot figure out what I need to change in order to set the Radio 2 5GHz to be on repeater mode. I have it setup between the two access points on Radio 1 and they show they are linked up, but on the 2nd access point I cannot set it to repeater mode, the options are grayed out, so only AP mode is available.
0
All Replies
-
Hi Customer,
If you would like to set Radio 2 as 5GHz to be on repeater mode, please configure Radio 1 as 2.4GHZ into AP mode first.
For your information: You can establish one Mesh link by choosing 2.4 GHz or 5 GHz.
Be a Community MVP: Win a VIP Deal Dash on Your Next Zyxel Purchase!
0 -
So only one of the two radios on the AP can be in repeater mode? What about extending the range of the other frequency / radio then? Basically this feels like instructions on how to make my exact same problem occur on a different frequency?0
Categories
- All Categories
- 383 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 76 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 890 Nebula FAQ
- 415 Security FAQ
- 233 Switch FAQ
- 203 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight