What is the procedure to construct the WDS between the standalone APs?
Options
Zyxel_Joslyn
Posts: 360 Zyxel Employee
0. Connect all APs to the switch through Ethernet cable
1. Go to CONFIGURATION > Network > IP Setting, and configure all the APs with static IP addresses.
2. Go to CONFIGURATION > Object > WDS Profile > WDS, and configure the WDS SSID. Also confirm the WDS SSID and Pre-Shared Key on all APs are the same.
3. (On root AP) Go to CONFIGURATION > Wireless > AP Management > WLAN Setting. Set the Radio 1 OP Mode as "Root AP", and choose the Radio 1 WDS Profile as "default"(it depends on the WDS profile that you configured.).
4. (On repeater AP) Go to CONFIGURATION > Wireless > AP Management > WLAN Setting. Set the Radio 1 OP Mode as "Repeater", and choose the Radio 1 WDS Profile as "default"(it depends on the WDS profile that you configured.).
5. Remove the cable line of the Repeater AP, and boot it up in the location you'd like to.
Verification
1. (On Root AP) Go to MONITOR > Wireless > WDS Downlink Info, and you will see the Repeater AP MAC address.
2. (On Repeater AP) Go to MONITOR > Wireless > WDS Uplink Info, and you will see the Root AP MAC address.
1. Go to CONFIGURATION > Network > IP Setting, and configure all the APs with static IP addresses.
2. Go to CONFIGURATION > Object > WDS Profile > WDS, and configure the WDS SSID. Also confirm the WDS SSID and Pre-Shared Key on all APs are the same.
3. (On root AP) Go to CONFIGURATION > Wireless > AP Management > WLAN Setting. Set the Radio 1 OP Mode as "Root AP", and choose the Radio 1 WDS Profile as "default"(it depends on the WDS profile that you configured.).
4. (On repeater AP) Go to CONFIGURATION > Wireless > AP Management > WLAN Setting. Set the Radio 1 OP Mode as "Repeater", and choose the Radio 1 WDS Profile as "default"(it depends on the WDS profile that you configured.).
5. Remove the cable line of the Repeater AP, and boot it up in the location you'd like to.
Verification
1. (On Root AP) Go to MONITOR > Wireless > WDS Downlink Info, and you will see the Repeater AP MAC address.
2. (On Repeater AP) Go to MONITOR > Wireless > WDS Uplink Info, and you will see the Root AP MAC address.
Tagged:
0
Categories
- All Categories
- 396 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 86 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 917 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 419 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight