
Allow communication between devices on different SSID

flaccidupsilon
Posts: 3


in Nebula
I created different SSIDs for specific bandwidth devices:
- SSID_A: 2.4GHz
- SSID_B: 5.0GHz
- SSID_C: 2.4 and 5.0GHz
DHCP is assigned by the router and uses a single pool of addresses. I have problems with devices on SSID_C from accessing devices on other SSID_A or _B. Is this expected behavior? Is there an advanced setting I can modify to allow all devices from different SSIDs to reach devices on another SSID?
0
All Replies
-
Hi there,
Devices are allowed or denied from accessing devices on other SSID that is not related to the bandwidth or radio.
We assume that you enable Guest network or Layer-2 Isolation for SSID_C. Layer 2 isolation will only allow the traffic of whitelisted destination MAC addresses. In case, if we configure L2 isolation and limit the traffic of a SSID, the traffic outgoing from that SSID will not be able to pass through.
You can check the two option as below:
1. Access point >> SSID advanced setting >> Advanced setting >> Layer-2 Isolation
2. Access point >> SSID setting >> Advanced setting >> Guest Network
You just disable Guest network or Layer-2 Isolation to allow all devices from different SSIDs to reach devices on another SSID.
0
Categories
- 8.1K All Categories
- 1.6K Nebula
- 59 Nebula Ideas
- 54 Nebula Status and Incidents
- 4.3K Security
- 222 Security Ideas
- 936 Switch
- 42 Switch Ideas
- 818 WirelessLAN
- 19 WLAN Ideas
- 5K Consumer Product
- 136 Service & License
- 266 News and Release
- 52 Security Advisories
- 13 Education Center
- 536 FAQ
- 252 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 66 About Community
- 44 Security Highlight