NSG200 nebula, vpn client gives p1 algorithm mismatch
Hello.
Our customer has several nsg200s.
the firewall is connected to each other via vpn. Then there is also a separate remote access vpn, which can be used to connect to different offices from the outside.
At one location, the vpn client gives a p1 algorithm mismatch error. in the firewall log you can find [SA] : Tunnel [Client_VPN] Phase 1 proposal mismatch.
The firewall is not behind the nat. Otherwise, the settings are the same as in other offices, excluding of course the ip settings and the user.
Does the firewall now for some reason have different algorithm settings than other firewalls?
How i fix this
Does the firewall now for some reason have different algorithm settings than other firewalls?
How i fix this
0
All Replies
-
update.
if i enable x-auth fron client (this must be enablet or it's not workin) then client gives p1 algorithm mismatch0
Categories
- All Categories
- 195 Beta Program
- 1.7K Nebula
- 93 Nebula Ideas
- 63 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 52 Switch Ideas
- 920 WirelessLAN
- 28 WLAN Ideas
- 5.4K Consumer Product
- 173 Service & License
- 296 News and Release
- 65 Security Advisories
- 14 Education Center
- 1K FAQ
- 453 Nebula FAQ
- 258 Security FAQ
- 100 Switch FAQ
- 115 WirelessLAN FAQ
- 22 Consumer Product FAQ
- 67 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 69 About Community
- 52 Security Highlight