pla6456 ethernet

diplexer
Posts: 1
Why does my pla6456 ethernet show ETHB as 100 and not 1000 even though I'm connected to a gigabit router with a 300Mbps internet connection? Using cat5e cables.
Ethernet | |||||||
External Interfaces: | |||||||
Interface | Speed | Duplex | Interface Type | Mode | Internal PHY | Link | |
---|---|---|---|---|---|---|---|
ETHA | 100 | FULL_DUPLEX | RGMII | MAC | NO | NO | |
ETHB | 100 | FULL_DUPLEX | SGMII | MAC | NO | YES |
0
All Replies
-
Hi @diplexer
Please check the router above the PLA if the port speed has been limited to 100M by the router.
If is is not able to change the port speed with the router, you can try to switch other ethernet cable and check if the ETHB still show 100 port speed.0
Categories
- 7.8K All Categories
- 1.6K Nebula
- 55 Nebula Ideas
- 53 Nebula Status and Incidents
- 4.3K Security
- 217 Security Ideas
- 908 Switch
- 40 Switch Ideas
- 807 WirelessLAN
- 16 WLAN Ideas
- 5K Consumer Product
- 131 Service & License
- 260 News and Release
- 49 Security Advisories
- 6 Education Center
- 573 FAQ
- 273 Nebula FAQ
- 132 Security FAQ
- 73 Switch FAQ
- 72 WirelessLAN FAQ
- 7 Consumer Product FAQ
- Documents
- 34 Nebula Monthly Express
- 67 About Community
- 40 Security Highlight
Consumer Product Help Center
