My clients, mostly IOT devices are being disconnected daily NWA50AX

m7urt

mMontana

Same channel for both APs might be not the best option, let's see if it works.

m7urt

i just switched one of the channels

Zyxel_Kay

Hi @m7urt

 

It’s happy to hear that no more disconnection happens again.  

  

From your screenshot, we know that some of your devices, which connected with “BLACKGATE-IOT”, its signal level is below -65 dbm. To maintain a better WiFi performance, it is recommended to place your device and AP become closer, then get your device signal level above –65 dbm.

Besides, if you know that which channel is having a great interference that makes your network performance being worse, you can manually adjust the channel deployment to the less interference channel one-by-one. Otherwise, it is recommended to enable your DCS setting, it will help your AP dynamically scans the environment and choosing a less interference channel.

Here is an article about tips to let you get a better WiFi network,  
Tips to help you improve your wireless network performance — Zyxel Community 

 

Hope this get help with you. 

  

Kay 

m7urt

All gone a bit wobbly this morning

m7urt

m7urt

I'm rebooting

mMontana

TASMOTA-T03 and TASMOTA-T09 have too low signal strength, IMVHO.

m7urt

the reboot connects them all again

m7urt

mMontana said:

TASMOTA-T03 and TASMOTA-T09 have too low signal strength, IMVHO.

yes that's right but they are quite a way from each AP, I'll sort that problem later. The bigger issue is the complete disconnection